Page 1 of 1
Final Step in the setup
Posted: 15 Dec 2009, 14:27
by Garryque
What do you do with the code in the final step. I'm unable to find any information on this step.Code is as follows. Thanks in Advance. Garry que
<?xml version="1.0"?>
<!DOCTYPE cross-domain-policy SYSTEM "
http://www.macromedia.com/xml/dtds/cros ... policy.dtd">
<cross-domain-policy>
<allow-access-from domain="*.cooliris.com" />
</cross-domain-policy>
Re: Final Step in the setup
Posted: 15 Dec 2009, 15:54
by Ronny
Hi Garry,
I assume this is needed if someone wants to enable the Cooliris 3D wall display with Phoca.
Regards,
Ronny
Re: Final Step in the setup
Posted: 15 Dec 2009, 23:50
by Garryque
yes not sure where the code goes?
Re: Final Step in the setup
Posted: 16 Dec 2009, 00:04
by Garryque
I think it has some thing to do with the database as when the program runs in the browser it comes up with this code in the window. The program then allows you to copy the code to the clip board and past it some where.Just not sure where to put it.
Re: Final Step in the setup
Posted: 16 Dec 2009, 16:14
by Jan
Hi, did you read the instructions in menu link to cooliris 3d wall?
Display Coolirs 3D Wall Layout in Phoca Gallery - Normally, Adobe Flash will prevent the wall from loading the RSS feed from your website. To allow the application to load your feed, you will need to place a crossdomain.xml file at the root of your website (You will find this file in Phoca Gallery installation ZIP package: ZIP Package/other/cooliris/crossdomain.xml)