Phoca Forum

But where are Joomfish files for Phoca Gallery? I'm getting it anywhere!!!

I've downloaded and unzipped Joomfish 2.0.4, but there are no file for PhocaGallery

Hi,

look here. I have also installed JoomFish 2.0.4 on my site and didn't need any other files than those to enable a working translation for Phoca Gallery.

Regards,
Ronny

I have followed the instructions and can now translate gallery content without issue.

The problem that I have though, is that when I first set the gallery up, I changed the preferences so that it showed 3 categories across the page. When I now change language, this preference is no longer used and it returns to 1 category per line as per the default.

Is there anywhere that I can set (reset) the categories per row so that it is the same in the original and in the translation.

Many thanks,

Mark.

Hi, check the parameters in menu link to gallery with parameters in joomfish (menu link to gallery) if you translate some menu link, then it get parameters in joomfish too, see:

https://www.phoca.cz/documents/2-phoca-g ... d-glossary

(at the bottom)

Jan wrote:Hi, check the parameters in menu link to gallery with parameters in joomfish (menu link to gallery) if you translate some menu link, then it get parameters in joomfish too, see:

https://www.phoca.cz/documents/2-phoca-g ... d-glossary

(at the bottom)

Hi Jan,

Thanks for the help. I would never have thought to look at the menu translation for this setting. This was partly due to the fact that I set it up in the component "preferences" rather than the menu in the first place. But it now works and is 3 columns for both the English and Spanish versions.

Thanks again,

Mark.

Great to hear it.

Jan

Hi,
All works fine, but I have question why if I change medium thumbnail resolution different than 100x100px in translations the images or still 100x100px. Only in default language version it shows good ones. How to change all thumbnails for example to 200x200px and the result in two language versions will be the same ?

Regards,
Wajri

Because parameters in Translations are not updated.
Open the translation and update according to default language item's parameters

almamun wrote:Because parameters in Translations are not updated.
Open the translation and update according to default language item's parameters

OK Thanks

Best Regards
Wajri